| About |
|---|
| We have engineered a range of materials specifically designed to address the requirements for automotive mats – the Dryflex AM range. These materials combine the performance of thermoset rubbers with the processability of plastics. Applications for Dryflex AM materials include floor mats, trunk liners, coin mats, fascia mats and trim. For automotive floor mats the material needs to have high scratch and abrasion resistance. It is also critical that the material is non-slip, even when wet. The material structure of Dryflex AM compounds produces the surface finish and high friction required. The range includes high-flow grades designed for complex mouldings with a large surface area such as trunk liners. Dryflex AM materials are low odour and fogging. They require no vulcanisation and are 100% recyclable during production. This means less energy is used and production is faster and more cost-efficient.&& |
| Product Description | |
|---|---|
| Generic | SEBS+SBS |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,Renewable resources,Quick molding cycle,Low to No Fogging,Low odor,Good wear resistance,Solvent resistance,High scratch resistance,Good coloring |
| Availabilitys | Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.10 | g/cm³ | ISO 2781 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 55 | ISO 868 | |
| Abrasion | 500 | mm³ | DIN 53516 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 3.00 | MPa | ISO 37 |
| tear strength | 15 | kN/m | ISO 34-1 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Operating temperature | -50 to 75 | ℃ |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | 3.00 | cm | FMVSS 302 |
| atomization | ISO 6452 | ||
| 80℃ | < 3.0E-4 | g | ISO 6452 |
| 100℃ | < 1.5E-3 | g | ISO 6452 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method C, Crescent |
| 3. 2mm wire supported |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |