| About |
|---|
| SUMIKON® FM-MK-150 is Glass fiber and inorganic filler filled Polyphenylene sulfide resin molding compound with good mechanical property grade. This grade is official registered UL with V-0 (t=1.0).&& |
| Product Description | |
|---|---|
| Supplier | SBHPP |
| Generic | PPS |
| Material Status | Commercial: Active |
| Features | V-0 |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 2.00 | g/cm³ | ASTM D792 |
| Shrinkage rate | Internal Method | ||
| MD | 0.20 | % | Internal Method |
| TD | 0.30 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 76.0 | MPa | ASTM D638 |
| Bending modulus | 17000 | MPa | ASTM D790 |
| bending strength | 146 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 42 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | > 260 | ℃ | ASTM D648 |
| Linear coefficient of thermal expansion | TMA | ||
| MD | 17 | ppm | TMA |
| TD | 23 | ppm | TMA |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.00 mm | V-0 | UL 94 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |