| About |
|---|
| The MC/AD1 Series is your material solution for applications requiring basic medical approvals such as ISO 10993-5. The series is characterized by excellent adhesion properties to polar thermoplastics such as PC, ABS, PC/ABS. The compounds are produced exclusively by a special medical unit. Typical applications Flexible Connections Membranes Seals Soft touch Valves Material advantages DMF listed Excellent mechanical properties For injection molding Free of animal basedingredients KRAIBURG TPE Medical service package (description below) Sterilizable (autoclave 134°C, gammaradiation 2×35 kGy, EtO) Tested according to ISO 10993-5&& |
| Product Description | |
|---|---|
| Supplier | KRAIBURG |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | ADCF,High pressure disinfection,Good bond,Radiation disinfection,Ethylene oxide disinfection |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.930 | g/cm³ | ISO 1183 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 3.00 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 550 | % | ISO 37 |
| tear strength | 8.0 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 13 | % | ISO 815 |
| 70℃，24 hr | 34 | % | ISO 815 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 34 | ISO 7619 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Adhesion to ABS | 3.0 | kN/m | Renault D41/1916 |
| Adhesion to PC | 3.0 | kN/m | Renault D41/1916 |
| Adhesion to PETG | 3.0 | kN/m | Renault D41/1916 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 60 to 80 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Barrel rear temperature | 180 | °C | |
| Barrel middle temperature | 210 | °C | |
| Barrel front temperature | 240 | °C | |
| Mold temperature | 40 to 60 | °C | |
| Injection pressure | 20.0 to 100 | MPa | |
| Back pressure | 2.00 to 10.0 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type S2, 7.9 in/min |
| 3. Method Bb, Angle (Nicked) |
| 4. Method A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |