| About |
|---|
| Dow Electrical and Telecommunications DGDA-1310 NT High Density Polyethylene Resin is a high performance resin with an outstanding balance of processability and toughness. Dow Electrical and Telecommunications DGDA-1310 NT is designed for use in wire and cable extrusion for Monosil process and both power and telecommunication jacketing. DGDA-1310 NT also has excellent electrical properties and superior environmental stress crack resistance. Specifications Dow Electrical and Telecommunications DGDA-1310 NT meets the following specification: ASTM D-1248 Type III, Class A, Category 5, Grade E9&& |
| Product Description | |
|---|---|
| Supplier | DOW |
| Generic | HDPE |
| Material Status | Commercial: Active |
| Availabilitys | North America,Latin America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.954 | g/cm³ | ASTM D792 |
| Melt Flow Rate | ASTM D1238 | ||
| 190℃，2.16kg | 0.28 | g/10min | ASTM D1238 |
| 190℃，21.6kg | 27 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 50 ℃, 100% non-ionic surfactant, F50 | > 1000 | hr | ASTM D1693 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 22.8 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | > 750 | % | ASTM D638 |
| Bending modulus | |||
| 2% secant | 1000 | MPa | ASTM D790-B |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -60.0 | ℃ | ASTM D746 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric constant | |||
| 1 MHz | 2.34 | ASTM D1531 | |
| Dissipation factor | |||
| 1 MHz | 1.0E-4 | ASTM D1531 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 232 to 249 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Plaque molded and tested in accordance with ASTM D4976. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |