| About |
|---|
| Filter-bond is a series of casting and potting compounds ideally suited for medical and food contact applications. This Filter-bond R-SERIES is manufactured to ultra-high quality standards and has been used by customers to pass biocompatibility requirements. The FILTER-bond R-30-6 Series feature 3 potting and adhesive systems specifically designed for potting and/or bonding Ultrafiltration products. The FILTER-bond R-30-6 Series DO NOT CONTAIN AROMATIC AMINES or other carcinogenic or mutenogenic materials.&& |
| Product Description | |
|---|---|
| Generic | 热固性聚酯 |
| Material Status | Commercial: Active |
| Features | Food contact compliance,Good bond,Agglomerability |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.14 | g/cm³ | ASTM D4669 |
| Shrinkage rate | |||
| MD | 0.15 to 0.30 | % | ASTM D2566 |
| Weight（per cubic inch） | 19 | g | |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 17 | J/m | ASTM D256 |
| Notched impact strength of cantilever beam | 31 | J/m | ASTM D256 |
| Thermosetting mixed viscosity | Nominal value | Unit | Test method |
|---|---|---|---|
| 25℃ | 11000 to 17000 | cP | ASTM D4878 |
| Gelation time | |||
| 25℃ | 21.0 to 31.0 | min | ASTM D2971 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Curing time | Internal Method | ||
| 21℃ | 1.0 | day | Internal Method |
| 80℃ | 0.3 to 0.4 | day | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 80 to 90 | ASTM D2240 | |
| Tensile modulus | 3100 | MPa | ASTM D638 |
| tensile strength | |||
| yield | 85.5 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 3.9 | % | ASTM D638 |
| Bending modulus | 3360 | MPa | ASTM D790 |
| bending strength | 101 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | 152 | ℃ | ASTM D648 |
| Thermosetting components | |||
| Component A | 按重量计算的混合比: 100, 按容量计算的混合比: 100 | ||
| Component B | 按重量计算的混合比: 20, 按容量计算的混合比: 20 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 100 g |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |