| About |
|---|
| Tunhe PBT TH6110 is a Polybutylene Terephthalate (PBT) product. It is available in Asia Pacific.&& |
| Product Description | |
|---|---|
| Supplier | Blueridge Tunhe |
| Generic | polybutylene terephthalate |
| Material Status | Commercial: Active |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.30 to 1.32 | g/cm³ | ASTM D792-B |
| Melt Flow Rate | 15 to 20 | g/10min | ASTM D1238 |
| Color b | 1.00 to 5.00 | GB/T 14190 | |
| Color L | > 90.0 | GB/T 14190 | |
| Particle Mass | 2.00 to 2.40 | g/100 pcs | GB/T 14190 |
| Intrinsic viscosity | 0.95 to 1.3 | dl/g | GB/T 14190 |
| water content | < 0.40 | % | GB/T 14190 |
| Ash Content | < 300 | ppm | GB/T 14190 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 50.0 to 60.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | > 200 | % | ASTM D638 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | > 40.0 | kJ/m² | ASTM D256-A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting peak temperature | > 222 | ℃ | ASTM D3418 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | |||
| 2 mm | > 2.0 | kV/mm | ASTM D149 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| End carboxyl group content | < 30.0 | mol/t | GB/T 14190 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Procedure A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |