| About |
|---|
| PB608 is a grade produced under high pressure in an autoclave reactor. This grade is especially designed for injection molding of articles that must show excellent flexibility properties and very good flow ability. Additive: No additives present. Applications: Masterbatches; Covers and injected parts with large flat area. Process: Injection Molding&& |
| Product Description | |
|---|---|
| Supplier | Braskem |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | Good flexibility,Good liquidity,Low density,High pressure heat resistance |
| Availabilitys | Latin America,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.915 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 30 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 42 | ASTM D2240 | |
| tensile strength | |||
| Fracture, molded | 9.00 | MPa | ASTM D638 |
| Yield, molding | 8.00 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, molded | 390 | % | ASTM D638 |
| Bending modulus | |||
| 1% cut, molded | 150 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 79.0 | ℃ | ASTM D1525 2 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |