UNITAL® SFX-0102M

About
UNITAL SFX-0102M extruded thermoplastic shapes provide users with the strength and dimensional stability inherent in POM-based resins as well as enhanced stiffness provided by the addition of a metallic filler. UNITAL SFX-0102M shapes offer low extractables for applications requiring FDA compliance and are especially well suited for metal detection in food processing applications. UNITAL SFX-0102M is available in multiple rod and plate configurations by special order. Minimums order quantities may apply due to the highly specialized nature of product applications, dependent on configuration.&&

About

UNITAL SFX-0102M extruded thermoplastic shapes provide users with the strength and dimensional stability inherent in POM-based resins as well as enhanced stiffness provided by the addition of a metallic filler. UNITAL SFX-0102M shapes offer low extractables for applications requiring FDA compliance and are especially well suited for metal detection in food processing applications. UNITAL SFX-0102M is available in multiple rod and plate configurations by special order. Minimums order quantities may apply due to the highly specialized nature of product applications, dependent on configuration.&&

Product Description
Generic	Paraformaldehyde
Material Status	Commercial: Active
Features	Good Rigidity,Low extract,Good Dimensional Stability,Food contact compliance,Metal Detectable
Availabilitys	North America,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.68	g/cm³	ASTM D792
Water absorption rate
24hr	< 0.20	%	ASTM D570

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	75	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	116	℃	ASTM D648
Glass transition temperature	160	℃	ASTM D3418
Linear coefficient of thermal expansion
MD	2.2E-4	1/℃	ASTM D696
Relative temperature index	60.0	℃	UL 746

MECHANICAL	Nominal value	Unit	Test method
Rockwell hardness
R-level	100		ASTM D785
Tensile modulus	2550	MPa	ASTM D638
tensile strength
yield	48.3	MPa	ASTM D638
Tensile strain
fracture	5.0 to 10	%	ASTM D638
Bending modulus	3170	MPa	ASTM D790
bending strength	68.9	MPa	ASTM D790

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.