| About |
|---|
| Product obtained by gas-phase copolymerization of ethylene with butene-1 in presence of complex metalorganic catalysts. Stabilization recipe: antacid, antioxydant, heat stabilizer, dispersant. Application: rotational moulding of general purpose rigid products&& |
| Product Description | |
|---|---|
| Generic | MDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Machinable,Acidproof,Inoxidizability,Heat Stabilized |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.938 to 0.942 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 3.5 to 4.5 | g/10min | ASTM D1238 |
| Melt flow ratio | |||
| MFR 21.6 kg/MFR 2.16 kg | < 28.0 | ASTM D1238 | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Bending modulus | 850 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 无断裂 | ASTM D256 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |