TECHNYL STAR® AF 218S V35 BLACK 21N

About
TECHNYL STAR® AF 218S V35 Black 21N is a polyamide 6.6 offering high flowability, reinforced with 35% of glass fiber, heat stabilized, for injection moulding. Due to its outstanding flow caracteristics, this grade shows exceptional processing behaviour and superior surface aspect of the finished part. This grade offers and excellent combination between thermal and mechanical properties.&&

Product Description
Supplier	DOMO
Generic	PA66
Material Status	Commercial: Active
Features	Good surface appearance,Heat Stabilized,Good Dimensional Stability,High liquidity
Availabilitys	Europe,Africa & Middle East
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.41	g/cm³
Water absorption rate
23℃，24hr	0.75	%

MECHANICAL	Nominal value	Unit
Tensile modulus
23℃	11000	MPa
tensile strength
Fracture, 23 ℃	200	MPa
Tensile strain
Fracture, 23 ℃	2.6	%
Bending modulus
23℃	9500	MPa
bending strength
23℃	280	MPa

IMPACT	Nominal value	Unit
Charpy Notched Impact Strength
23℃	12	kJ/m²
Charpy Unnotch Impact strength
23℃	75	kJ/m²

THERMAL	Nominal value	Unit
Hot deformation temperature
1.8 MPa, unannealed	255	℃
Melting temperature	262	℃

Process Conditions
Injection	Nominal value	Unit	Test method
Injection instructions	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	265 to 275	°C
Temperature in the middle of the barrel	270 to 280	°C
Front temperature of material barrel	280 to 290	°C
Mold temperature	50 to 90	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.