Xydar® MG-350PRL

About

Product Description
Supplier	ENEOS
Generic	液态聚合物
Material Status	Commercial: Negative
Availabilitys	Asia Pacific,North America,Europe
Process Methods	Injection Molding

Technical Data
IMPACT	Nominal value	Unit	Test method
Notched impact strength of cantilever beam	42	KJ/m²	ASTM D256

MECHANICAL	Nominal value	Unit	Test method
tensile strength
3.2mm	116	MPa	ASTM D638
elongation
3.2mm	3.0	%	ASTM D638
bending strength
3.2mm	160	MPa	ASTM D790
Bending modulus
3.2mm	13.3	MPa	ASTM D790

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8MPa	275	℃	ASTM D648
Thermal conductivity coefficient	0.361	W/m/K	ASTM F433

PHYSICAL	Nominal value	Unit	Test method
Density	1.78	g/cm³	ASTM D792
Poisson’s ratio	0.33
Water absorption rate	≤0.02	%	ASTM D570

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Flame retardant level
0.17mm	V-0		UL 94

Electrical performance	Nominal value	Unit	Test method
Volume resistivity	1E+16	ohm·cm	ASTM D257
Surface resistivity	1E+16	ohm	ASTM D257
Dielectric constant
1 GHz	4.2
10GHz	4.0
Dissipation factor
Tangent, 1 GHz	0.004
Tangent, 10GHz	0.004

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.