| About |
|---|
| AVALON 75 AE is a general purpose polyester based thermoplastic polyurethane for injection moulding. AVALON 75 AE is part of the AVALON Soft Range and offers a premium soling material for casual, sport and protective footwear. The features offered include: Durability Excellent surface definition Abrasion resistance Slip resistance Phthalate free TPU&& |
| Product Description | |
|---|---|
| Supplier | Huntsman |
| Material Status | Commercial: Active |
| Features | Good surface appearance,Durability,Good wear resistance |
| Availabilitys | Europe,North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.22 | g/cm³ | DIN 53479 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| 75 | Shore A | DIN 53505 | |
| – | Shore D | DIN 53505 | |
| Tensile Strength | 24 | MPa | DIN 53504 |
| Elongation at Break | 600 | % | DIN 53504 |
| Tensile Modulus | |||
| 100% | 4 | MPa | DIN 53504 |
| 300% | 7 | MPa | DIN 53504 |
| Tear strength | 70 | kN/m | DIN 53515 |
| 20 | % | DIN 53517 | |
| Abrasion Resistance | 35 | mm³ | DIN 53516 |
| OTHER | Nominal value | Unit | Test method |
|---|---|---|---|
| Ross Flex | 250 | k.cycles | BS 5131 |
| Process Conditions | |||
|---|---|---|---|
| Injection Molding | Nominal value | Unit | Test method |
| Drying Temperature | 80 to 90 | °C | |
| Drying Time | 2.0 | hr | |
| Hopper Temperature | 25 to 35 | °C | |
| Rear Temperature Zone 1 | 175 to 185 | °C | |
| Middle Temperature Zone 2 | 180 to 190 | °C | |
| Front Temperature Zone 3 | 185 to 195 | °C | |
| Nozzle temperature | 175 to 190 | °C | |
| Mold Temperature | 25 to 50 | °C | |
| Injection pressures | 2.00 to 10.0 | MPa | |
| Injection speed | Slow | ||
| Maintain pressure | 1.00 to 5.00 | MPa | |
| Back Pressure | 0.0300 to 0.300 | MPa | |
| Screw Speed | 20 to 80 | rpm | |
| Screw L/D ratio | 20.0:1.0 to 25.0:1.0 | ||
| Screw Compression Ratio | 2.0:1.0 to 3.0:1.0 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. BS 5131 |
| 3. Method Ba, Angle (Unnicked) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |