| About |
|---|
| Neoflon® FEP NP-20 was developed for extrusion of thin coatings of small wire sizes such as plenum cable, appliance wire, thin film and tubing, etc. It may also be used for injection molding of thin wall parts.&& |
| Product Description | |
|---|---|
| Supplier | Daikin Fluorochemicals |
| Generic | FEP |
| Material Status | Commercial: Active |
| Features | Good Electrical Properties,Copolymer |
| Availabilitys | North America,Asia Pacific |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 2.12 to 2.17 | g/cm³ | ASTM D2116 |
| Melt Flow Rate | |||
| 372℃，2.16kg | 4.5 to 8.5 | g/10min | ASTM D2116 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 19.6 to 34.3 | MPa | ASTM D2116 |
| Tensile strain | |||
| fracture | 300 to 400 | % | ASTM D2116 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 265 to 275 | ℃ | ASTM D2116 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. DSC |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |