| About |
|---|
| Reinforced Polyethylene Compound AA-Recoplast designed to offer excellent stiffness, low warping, good/acceptable toughness, and good moldability (extrudability). This resin is ideally suited for injection molded crates, cases, trays, tote, bins and other objects requiring high rigidity. Regulatory status AA-Recoplast grades complies with Food Contact Regulation upon request.&& |
| Product Description | |
|---|---|
| Generic | PE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Low warping,Excellent Processability,Good flexibility,Renewable resources,Food contact compliance |
| Availabilitys | Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.970 | g/cm³ | ISO 1183 |
| Apparent density | 0.51 | g/cm³ | ISO 60 |
| Melt Flow Rate | ISO 1133 | ||
| 190℃，2.16kg | 0.20 | g/10min | ISO 1133 |
| 190℃，21.6kg | 60 | g/10min | ISO 1133 |
| 190℃，5.0kg | 5.0 | g/10min | ISO 1133 |
| Water absorption rate | |||
| Equilibrium, 23 ℃, 50% RH | 0.010 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | ISO 868 | ||
| Shaw’s A | 90 | ISO 868 | |
| Shaw’s D | 56 | ISO 868 | |
| Tensile modulus | > 1500 | MPa | ISO 527-2 |
| tensile strength | |||
| fracture | > 48.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | > 16 | % | ISO 527-2 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Barrel rear temperature | 180 to 190 | °C | |
| Barrel middle temperature | 180 to 190 | °C | |
| Barrel front temperature | 180 to 190 | °C | |
| Nozzle temperature | 180 to 190 | °C | |
| Processing (melt) temperature | 190 to 250 | °C | |
| Barrel 1 zone temperature | 180 to 190 | °C | |
| Barrel 2 zone temperature | 180 to 190 | °C | |
| Barrel 3 zone temperature | 180 to 190 | °C | |
| Melt temperature | 190 to 250 | °C | |
| Nozzle temperature | 180 to 190 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |