Aarolene® ARPE LD 300-1

About
A COMPOUNDED LDPE BLACK LOW MELT RESIN SPECIFICALLY DESIGNED FOR ALL PROFILE EXTRUSION APPLICATIONS.&&

Product Description
Generic	LDPE
Material Status	Commercial: Active
Features	Low density
Availabilitys	North America
Process Methods	Profile extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.918	g/cm³	ASTM D792
Melt Flow Rate
190℃，2.16kg	6.0	g/10min	ASTM D1238
Shrinkage rate
MD	1.5	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
tensile strength
Yield, 23 ℃	11.0	MPa	ASTM D638
Bending modulus	1650	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	无断裂		ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	82.2	℃	ASTM D648

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.