ADMER™ AT2866E

About
ADMER™ AT2866E is a maleic anhydride grafted, LLDPE-based grade, which is designed for adhesion between PE and PA or EVOH in tube, sheet, blown and cast film and contains less additives than standard grades.

Product Description
Supplier	Mitsui
Generic	MAH-g-PE增容剂
Material Status	Commercial: Active
Features	Food contact compliance,Good bond
Availabilitys	Africa & Middle East ,Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.910	g/cm³	ASTM D1505
Melt Flow Rate
190℃，2.16kg	3.0	g/10min	ASTM D1238

IMPACT	Nominal value	Unit	Test method
Notched impact strength of cantilever beam	无断裂		ASTM D256

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	80.0	℃	ASTM D1525

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	44		ASTM D2240
Tensile strength
yield	7.00	MPa
fracture	14.0	MPa
Tensile strain
fracture	> 500	%	ASTM D638

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.