| About |
|---|
| ADMER™ AT3158E is a PE-based adhesive for 3-layer steel pipe coating with a strong adhesion between PE and epoxy materials. |
| Product Description | |
|---|---|
| Supplier | Mitsui |
| Generic | MAH-g-PE增容剂 |
| Material Status | Commercial: Active |
| Features | Good bond |
| Availabilitys | Africa & Middle East ,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.928 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 2.0 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 95.0 | ℃ | ASTM D1525 |
| Melting peak temperature | 127 | °C | ASTM D3418 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 50 | ASTM D2240 | |
| Tensile strength | |||
| yield | 12.5 | MPa | |
| fracture | 22.8 | MPa | |
| Tensile strain | |||
| fracture | > 600 | % | ASTM D638 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |