| About |
|---|
| Akulon® S240-CH Inj-Mold is a Polyamide 66 (Nylon 66) material. It is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America for injection molding. Primary attribute of Akulon® S240-CH Inj-Mold: Flame Rated.&& |
| Product Description | |
|---|---|
| Supplier | DSM |
| Generic | PA6 |
| Material Status | Commercial: Negative |
| Features | Heat Stabilized,High Viscosity |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Viscosity number | 280 | cm³/g | ISO 307, 1157, 1628 |
| Density | 1140 | kg/m³ | ISO 1183 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Coeff. of linear thermal expansion | |||
| parallel | 0.9 | E-4/°C | ISO 11359-2 |
| Supplementary Information | Nominal value | Unit | Test method |
|---|---|---|---|
| Oxygen transmittance at 23 ° C/0% RH | 27 | cm³/(m²*d*bar) | DIS 15105-1/-2 |
| Oxygen transmittance at 23 ° C/85% RH | 41 | cm³/(m²*d*bar) | DIS 15105-1/-2 |
| Moisture transmittance (23 ° C/85% RH) | 24 | g/(m²*d) | DIS 15106-1/-3 |
| Sample thickness | 0.06 | mm | |
| Cooling roller temperature | 100 | ℃ |
| Process Conditions | |||
|---|---|---|---|
| Injection Molding | Nominal value | Unit | Test method |
| Drying Temperature | 80 | °C | |
| Drying Time | 2.0 to 4.0 | hr | |
| Rear Temperature Zone 1 | 230 to 235 | °C | |
| Middle Temperature Zone 2 | 235 to 250 | °C | |
| Front Temperature Zone 3 | 240 to 260 | °C | |
| Nozzle temperature | 240 to 270 | °C | |
| Melt Temperature | 240 to 275 | °C | |
| Mold Temperature | 50 to 80 | °C | |
| Back Pressure | 3.00 to 10.0 | MPa | |
| Screw Compression Ratio | 2.5:1.0 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 10°C/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |