| About |
|---|
| ALCOM® TCE PC 5020 15011 is a Polycarbonate (PC) product filled with 20% filler. It can be processed by coextrusion, extrusion, profile extrusion, or sheet extrusion and is available in Asia Pacific, Europe, or North America. Applications of ALCOM® TCE PC 5020 15011 include electrical/electronic applications, lighting applications and sheet. Characteristics include: RoHS Compliant Antistatic Conductive Heat Resistant&& |
| Product Description | |
|---|---|
| Supplier | ALBIS |
| Generic | Polycarbonate |
| Material Status | Commercial: Active |
| Features | Good heat aging resistance,Thermal conductivity,Antistatic property |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Profile extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.29 | g/cm³ | ISO 1183 |
| Shrinkage rate | |||
| TD | > 0.50 | % | |
| MD | > 0.60 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 2450 | MPa | ISO 527-2 |
| tensile strength | 45.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | 8.0 | % | ISO 527-2 |
| Bending modulus | 2900 | MPa | ISO 178 |
| bending strength | 75.0 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | 8.0 | kJ/m² | ISO 179-1eA |
| Charpy Unnotch Impact strength | 60 | kJ/m² | ISO 179/1eU |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Thermal conductivity coefficient | |||
| — | 0.50 | W/m/K | ASTM E1461 |
| — | 1.1 | W/m/K | ASTM E1461 |
| — | 0.70 | W/m/K | ISO 22007-2 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | < 1.0E+2 | ohms | IEC 60093 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature – hot air dryer | 100 to 120 | °C | |
| Drying time – hot air dryer | 2.0 to 3.0 | hr | |
| Recommended maximum moisture content | < 0.020 | % | |
| Melt temperature | 260 to 290 | °C | |
| Nozzle temperature | 230 to 240 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. through-plane |
| 3. in-plane |
| 4. integral |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |