| About |
|---|
| EBA copolymer ALCUDIA® PA-1704 is a copolymer suitable for blown film applications where good processability, flexibility and good mechanical properties are required. The butyl acrylate content is 17%. It contains antioxidant additives. EBA ALCUDIA® PA-1704 fulfils the food contact regulations in most countries. For further information or certificates, contact our Customer Service Offices. APPLICATIONS Film extrusion Stretch hood film Recommended melt temperature range is 160 to 180°C. EBA copolymers exhibit excellent thermal stability, which allows higher processing temperatures if needed. Processing characteristics of PA-1704 are similar to LDPE and conventional Polyethylene extruders are recommended.&& |
| Product Description | |
|---|---|
| Supplier | REPSOL |
| Generic | EBA |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good flexibility,Food contact compliance,Inoxidizability |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.925 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.40 | g/10min | ISO 1133 |
| Butyl acrylate composition | 17.0 | wt% | |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | |||
| test | 100 | µm | |
| tensile strength | ISO 527-3 | ||
| MD, fracture, 100 µ m, blow molded film | 20.0 | MPa | ISO 527-3 |
| TD, fracture, 100 µ m, blow molded film | 22.0 | MPa | ISO 527-3 |
| Tensile strain | ISO 527-3 | ||
| MD, fracture, 100 µ m, blow molded film | 700 | % | ISO 527-3 |
| TD, fracture, 100 µ m, blow molded film | 800 | % | ISO 527-3 |
| Drop hammer impact | |||
| 100 µ m, blow molded film | > 1400 | g | ISO 7765-1 |
| Elmandorf tear strength | ISO 6383-2 | ||
| MD：100.0 µm | 36.0 | kN/m | ISO 6383-2 |
| TD：100.0 µm | 39.0 | kN/m | ISO 6383-2 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 96.0 | ℃ |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 160 to 180 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Blown Film |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |