| About |
|---|
| ALTECH® PA6 + ASA A 1000/312 IM UV is an Acrylonitrile Styrene Acrylate + PA (ASA+Nylon) product. It can be processed by injection molding and is available in Asia Pacific, Europe, or North America. Typical application: Automotive. Characteristics include: RoHS Compliant Good Aesthetics Heat Resistant Heat Stabilizer High Dimensional Stability&& |
| Product Description | |
|---|---|
| Supplier | ALBIS |
| Generic | ASA+PA |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good heat aging resistance,Good surface appearance,High impact resistance,Good Dimensional Stability,Low or no water absorption,High scratch resistance,Heat Stabilized |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.09 | g/cm³ | ISO 1183 |
| Melt Volume Rate | |||
| 260℃，5 kg | 6.00 | cm³/10min | ISO 1133 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| — | 70 | kJ/m² | |
| -40℃ | 10 | kJ/m² | |
| Charpy Unnotch Impact strength | 无断裂 | ISO 179/1eU |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 60.0 | ℃ | ISO 75-2/A |
| Vicat Softening Temp | |||
| B50 | 134 | ℃ | ISO 306 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Ball hardness | |||
| H358/30 | 101 | MPa | ISO 2039-1 |
| Tensile modulus | 2000 | MPa | ISO 527-2 |
| tensile strength | |||
| yield | 45.0 | MPa | |
| fracture | 40.0 | MPa | |
| Tensile strain | |||
| yield | 3.4 | % | |
| fracture | 30 | % | |
| Bending modulus | 1900 | MPa | ISO 178 |
| bending strength | 65.0 | MPa | ISO 178 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature – hot air dryer | 80 | °C | |
| Drying time – hot air dryer | 2.0 to 12 | hr | |
| Recommended maximum moisture content | < 0.10 | % | |
| Processing (melt) temperature | 240 to 280 | °C | |
| Mold temperature | 40 to 80 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |