| About |
|---|
| Andur M-22 is an MDI-Ester prepolymer that, when processed with close attention to handling procedures and formulation, produces high quality elastomers. These elastomers perform very well in dynamic applications.&& |
| Product Description | |
|---|---|
| Generic | PUR-酯+MDI |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| elastic body | Nominal value | Unit | Test method |
| tensile strength | ASTM D412 | ||
| yield | 31.0 | MPa | ASTM D412 |
| 100% strain | 10.0 | MPa | ASTM D412 |
| 300% strain | 17.2 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 550 | % | ASTM D412 |
| Compression deformation | 35 | % | ASTM D395 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| storage stability | 6.0 to 10 | min | |
| stripping time | 90 | min |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | ASTM D2240 | ||
| Shaw’s A | 96 | ASTM D2240 | |
| Shaw’s D | 43 | ASTM D2240 | |
| compressive strength | ASTM D695 | ||
| 2% strain | 1.17 | MPa | ASTM D695 |
| 5% strain | 2.41 | MPa | ASTM D695 |
| 10% strain | 3.79 | MPa | ASTM D695 |
| 15% strain | 5.17 | MPa | ASTM D695 |
| 20% strain | 6.76 | MPa | ASTM D695 |
| 25% strain | 8.27 | MPa | ASTM D695 |
| Taber abraser | 16.9 | mg | ASTM D1044 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Mold temperature | 110 to 140 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |