| About |
|---|
| APICAL 150AF019 APICAL 150AF019 is a Thermoset Polyimide material. It is available in North America. Important attributes of APICAL 150AF019 are: Flame Rated Chemical Resistant Flame Retardant Good Sealability Moisture Resistant Typical application of APICAL 150AF019: Film&&APICAL 150AF019 APICAL 150AF019 is a PI Film material. It is available in Latin America or North America.&& |
| Product Description | |
|---|---|
| Supplier | Kaneka |
| Generic | PI |
| Material Status | Commercial: Active |
| Features | Good heat sealing,Flame Characteristics,Moisture resistance,Solvent resistance,V-0 |
| Availabilitys | North America,Latin America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.53 | g/cm³ | ASTM D1505 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | |||
| test | 38 | µm | |
| Secant modulus | |||
| 1% secant, MD | 2790 | MPa | ASTM D882 |
| tensile strength | |||
| MD, fracture | 193 | MPa | ASTM D882 |
| Tensile strain | |||
| MD, fracture | 90 | % | ASTM D882 |
| Elmandorf tear strength | |||
| MD | 18 | g | ASTM D1922 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Relative temperature index | |||
| Electrical performance, 0.038 mm | 240 | ℃ | UL 746 |
| 0.038 mm | 210 | ℃ | UL 746 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 1.0E+15 | ohms·cm | ASTM D257 |
| Dielectric strength | 180 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 1 kHz | 3.20 | ASTM D150 | |
| Dissipation factor | |||
| 1 kHz | 1.2E-3 | ASTM D150 | |
| Arc resistance | |||
| 0.038 mm | 60.0 | sec | ASTM D495 |
| Compared to the resistance to leakage and marking index | |||
| 0.0380 mm | 213 | V | UL 746 |
| High Arc Burning Index (HAI) (0.0380 mm) | 15.0 | UL 746 | |
| High voltage arc marking rate (HVTR) (0.0380 mm) | 150 | mm/min | UL 746 |
| Hot wire ignition (HWI) (0.0380 mm) | 120 | sec | UL 746 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 0.038 mm | V-0 | UL 94 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 500 V/sec |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |