| About |
|---|
| apinat® A 75 is a Thermoplastic Elastomer (TPE) product. It can be processed by extrusion or injection molding and is available in Europe. Typical application: Engineering/Industrial Parts. Characteristics include: Eco-Friendly/Green Weather Resistant&& |
| Product Description | |
|---|---|
| Generic | TPE |
| Material Status | Commercial: Negative |
| Features | Weather resistance is good,Biodegradable |
| Availabilitys | Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.19 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | 50.0 | kN/m | ASTM D624 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Ozone resistance | |||
| 40℃ | Good |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds | 75 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| — | 11.0 | MPa | ASTM D638 |
| 100% strain | 3.00 | MPa | ASTM D638 |
| 300% strain | 5.00 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 750 | % | ASTM D638 |
| abrasion resistance | 140 | mm³ | DIN 53516 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 2.0 | hr | |
| Recommended maximum moisture content | 0.10 | % | |
| Barrel rear temperature | 120 to 140 | °C | |
| Barrel middle temperature | 130 to 150 | °C | |
| Barrel front temperature | 140 to 160 | °C | |
| Nozzle temperature | 150 to 170 | °C | |
| Mold temperature | 25 to 35 | °C | |
| Drying temperature | 80 | °C | |
| Drying time | 2.0 | hr | |
| Recommended maximum moisture content | 0.10 | % | |
| Barrel 1 zone temperature | 110 to 130 | °C | |
| Barrel 2 zone temperature | 130 to 140 | °C | |
| Barrel 3 zone temperature | 135 to 145 | °C | |
| Barrel 4 zone temperature | 140 to 150 | °C | |
| Nozzle temperature | 140 to 150 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 72 hr, 200 ppcm, Tension = 20% |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |