| About |
|---|
| Applications: Hot melt adhesive Textile lamination Characteristics: Low melt, high tack for excellent melt adhesion Enhanced UV stability Low slip for maximum adhesion to many substrates Good elasticity for use where soft, rubber-like, low-additive TPU is desired&& |
| Product Description | |
|---|---|
| Generic | TPU |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good bond,Low smoothness |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.13 | g/cm³ | ASTM D792 |
| Melt Flow Rate | 49 | g/10min | ASTM D1238 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D638 | ||
| fracture | 31.0 | MPa | ASTM D638 |
| 100% strain | 8.27 | MPa | ASTM D638 |
| 300% strain | 13.8 | MPa | ASTM D638 |
| tear strength | 70.0 | kN/m | ASTM D624 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Continuous use temperature | -54.0 to 79.0 | ℃ | ASTM D794 |
| Melting temperature | 150 to 165 | ℃ |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 80 | ASTM D2240 | |
| Tensile permanent deformation | 20 | % | ASTM D638 |
| Tensile strain | |||
| fracture | 450 | % | ASTM D638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |