ASTALOY™ PC/ABS M130S

About
ASTALOY™ PC/ABS M130S is a high melt flow alloy of ABS and Polycarbonate and is designed for long flow path injection moulding applications requiring a balance of impact toughness, product rigidity, heat resistance and mouldability. Typical automotive applications include painted exterior body panels, instrument panel substrates, remote locking keypads and tailgate upper air deflectors. Note: The letters “U” or “W” indicate UV stabilisation has been added [ ie: ASTALOY™ PC/ABS M130SU ].&&

Product Description
SupplierMarplex
GenericPC+ABS
Material StatusCommercial: Active
FeaturesWeather resistance is good,Excellent Processability,High impact resistance,High liquidity,Sprayable,Heat Resistance, Good,HB
AvailabilitysNorth America,Latin America,Asia Pacific
Process MethodsInjection Molding

Technical Data
PHYSICALNominal valueUnitTest method
Density1.12g/cm³ASTM D792
Melt Flow Rate
250℃,3.80kg12g/10minASTM D1238
Shrinkage rate
MD:3.0 mm0.60%ASTM D955
Water absorption rate
24hr0.25%ASTM D570

IMPACTNominal valueUnitTest method
Impact strength of cantilever beam notch
3.2mm630J/mASTM D256
Drop hammer impact
3.2 mm55.0JASTM D3029

THERMALNominal valueUnitTest method
Hot deformation temperature ASTM D648
1.8 MPa, unannealed, 3.2 mm98.0ASTM D648
1.8 MPa, unannealed, 6.4 mm100ASTM D648
1.8 MPa, unannealed, 12.7 mm106ASTM D648
Vicat Softening Temp132ASTM D1525 4
Linear coefficient of thermal expansion
MD7.2E-51/℃ASTM D696

FLAME CHARACTERISTICSNominal valueUnitTest method
1.60 mmHB UL 94
Igniting temperature of the hot wire
1.6 mm550AS/NZS 60695.2.12

MECHANICALNominal valueUnitTest method
Rockwell hardness
R-level115 ASTM D785
tensile strength
3.20 mm55.0MPaASTM D638
Tensile strain
Fracture, 3.20 mm100%ASTM D638
Bending modulus
3.20 mm2400MPaASTM D790
bending strength
3.20 mm85.0MPaASTM D790

Process Conditions
injectionNominal valueUnitTest method
Drying temperature95 to 100°C
Drying time3.0 to 5.0hr
Barrel rear temperature235 to 255°C
Barrel middle temperature245 to 265°C
Barrel front temperature255 to 275°C
Processing (melt) temperature250 to 280°C
Mold temperature50 to 90°C
Injection pressure60.0 to 140MPa

Notes
1. Typical properties: these are not to be construed as specifications.
2. 0.20 in/min
3. 0.051 in/min
4. Loading 1 (10 N)
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.