| About |
|---|
| A high rate, midrange gloss, PVC powder, extrusion compound for exterior/interior applications. Typical test results for ASTM D-4216. This is a Rigid PVC formulation per the requirements of AAMA 303-05. Testing was performed on actual window parts with a wall thickness of 0.100″. This material meets/exceeds cell class 1-20131-13**as required in ASTM D-4726. Testing was performed by Dallas Laboratory, Inc., July 2006.&& |
| Product Description | |
|---|---|
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.45 to 1.47 | g/cm³ | ASTM D792 |
| PVC unit classification | 1-43344-12 | ASTM D4216 | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore D, 22 ℃ | 75 to 81 | ASTM D2240 | |
| Tensile modulus | |||
| 22℃ | 3010 | MPa | ASTM D638 |
| tensile strength | |||
| Yield, 22 ℃ | 46.2 | MPa | ASTM D638 |
| Bending modulus | |||
| 22℃ | 2650 | MPa | ASTM D790 |
| bending strength | |||
| 22℃ | 80.0 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 22℃ | 980 | J/m | ASTM D256 |
| Falling impact resistance | ASTM D4226 | ||
| 22℃，Extruded at 370 to 380° F melt temperature | > 120 | J/cm | ASTM D4226 |
| 22℃，Extruded at 370 to 380° F melt temperature | > 120 | J/cm | ASTM D4226 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 70.6 | ℃ | ASTM D648 |
| Linear coefficient of thermal expansion | |||
| MD：22℃ | 5.2E-5 | 1/℃ | ASTM D696 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Burning rate | ASTM D635 | ||
| （AEB）Avg.Extent of Burning | < 5.00 | mm/min | ASTM D635 |
| （ATB）Avg.Time of Burning：2.54 mm | < 5.0 | sec | ASTM D635 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Procedure A |
| 3. Procedure B |
| 4. Instantaneous |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |