AXELERON™ CC 3485 NT CPD

About
AXELERON™ CC 3485 NT CPD is an expandable, high-molecular weight, high-density polyethylene insulation compound (“CPD”) specifically formulated for foam/skin telephone singles. It incorporates a chemical blowing agent which enables this material to attain up to 50 percent expansion via temperature-controlled extrusion. This highly stabilized product has superior mechanical and electrical properties and has been designed for high-speed extrusion. Specifications: Telephone wire insulated with AXELERON™ CC 3485 NT CPD using sound commercial extrusion practices, should meet the following cable specifications: REA PE “Filled Telephone Cable with Expanded Insulation” ICEA S-84-608 “Telecommunications Cable; Filled, Polyolefin Insulated, Copper Conductor – Technical Requirements”&&

About

AXELERON™ CC 3485 NT CPD is an expandable, high-molecular weight, high-density polyethylene insulation compound (“CPD”) specifically formulated for foam/skin telephone singles. It incorporates a chemical blowing agent which enables this material to attain up to 50 percent expansion via temperature-controlled extrusion. This highly stabilized product has superior mechanical and electrical properties and has been designed for high-speed extrusion. Specifications: Telephone wire insulated with AXELERON™ CC 3485 NT CPD using sound commercial extrusion practices, should meet the following cable specifications: REA PE “Filled Telephone Cable with Expanded Insulation” ICEA S-84-608 “Telecommunications Cable; Filled, Polyolefin Insulated, Copper Conductor – Technical Requirements”&&

Product Description
Supplier	DOW
Generic	HDPE
Material Status	Commercial: Active
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.945	g/cm³	ASTM D792
Melt Flow Rate
190℃，2.16kg	0.85	g/10min	ASTM D1238

MECHANICAL	Nominal value	Unit	Test method
tensile strength	22.1	MPa	ASTM D638
Tensile strain
fracture	700	%	ASTM D638

THERMAL	Nominal value	Unit	Test method
Heat resistant stress cracking
F0	> 96	hr	ASTM D2951

Electrical performance	Nominal value	Unit	Test method
Volume resistivity
23℃	> 1.0E+15	ohms·cm	ASTM D257
Dielectric constant
1 MHz	2.34		ASTM D1531
Dissipation factor
1 MHz	3.0E-4		ASTM D1531

Notes
1. Typical properties: these are not to be construed as specifications.
2. Solid
3. Base resin
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.