| About |
|---|
| AZR Ecoplast 143 HDPE red 0.4 is high impact resistance in — extruder made thermoplastic polyethylene with a low temperature plastic composite profile for injection molding. AZR Ecoplast 143 HDPE red 0.4 is controlled technology extra high impact resistance thermoplastic polyethylene with rheological properties even at low temperatures. Applications: AZR Ecoplast 143 HDPE red 0.4 is designed to offer excellent stiffness, low warping, good/acceptable toughness, plasticity and good moldability (extrudability). This resin is ideally suited for injection molded crates, cases, trays, tote, containers, bins and other objects requiring high rigidity. Food Contact: AZR Ecoplast 143 HDPE red 0.4 complies with EU directive 10/2011.&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Low warping,Excellent Processability,Good flexibility,High impact resistance,Renewable resources,Controllable rheological,Food contact compliance,low-temperature impact resistance |
| Availabilitys | Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.950 | g/cm³ | ISO 1183 |
| Apparent density | 0.51 | g/cm³ | ISO 60 |
| Melt Flow Rate | ISO 1133 | ||
| 190℃，2.16kg | 0.41 to 0.45 | g/10min | ISO 1133 |
| 190℃，5.0kg | 2.0 to 2.2 | g/10min | ISO 1133 |
| humidity | |||
| External | 0.20 to 0.40 | % | Internal Method |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy impact strength | 200 | J/m | ISO 148 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Odor（15 estimators） | 1.00 | points | EN 13752 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | ASTM D2240 | ||
| Shaw’s A | 94 | ASTM D2240 | |
| Shaw’s D | 63 | ASTM D2240 | |
| Tensile modulus | > 1690 | MPa | ISO 527-2 |
| tensile strength | |||
| fracture | > 27.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | > 57 | % | ISO 527-2 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 180 to 190 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Nexis fiber method |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |