| About |
|---|
| MB 1150 is an Avocado colored rigid closed-cell polyurethane foam tooling and modeling board. MB 1150 is low density foam of approximately 15lbs/ft³ board. Easily cut using CNC machining equipment or by hand the MB 1150 is perfectly suited for temporary master models, architectural design models, foundry patterns as well as design verification and prototype tools.&& |
| Product Description | |
|---|---|
| Generic | PUR |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good surface appearance,Good Dimensional Stability,Foaming performance,Low contractility,Machinable,Good wear resistance |
| Availabilitys | North America |
| Process Methods | Foam treatment |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.240 | g/cm³ | ASTM D1505 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 71.1 | ℃ | ASTM D648 |
| Continuous use temperature | 40.6 to 257 | ℃ | ASTM D794 |
| Linear coefficient of thermal expansion | |||
| MD | 5.9E-5 | 1/℃ | ASTM D696 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 30 | ASTM D2240 | |
| tensile strength | 4.14 | MPa | ASTM D638 |
| bending strength | 5.38 | MPa | ASTM D790 |
| compressive strength | 3.86 to 4.07 | MPa | ASTM D695 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |