| About |
|---|
| BMC A50 (MS) is a Thermoset Polyester product. It is available in North America. Typical application: Appliances. Primary characteristic: flame rated.&& |
| Product Description | |
|---|---|
| Generic | 热固性聚酯 |
| Material Status | Commercial: Active |
| Features | V-0 |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.93 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 0.25 to 0.30 | % | ASTM D955 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 320 | J/m | ASTM D256 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 15 | kV/mm | ASTM D149 |
| Arc resistance | 191 | sec | ASTM D495 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | UL 94 | ||
| 1.50 mm | V-0 | UL 94 | |
| 2.20 mm | V-0 | UL 94 | |
| 3.10 mm | V-0 | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 54.5 | MPa | ASTM D638 |
| Bending modulus | 8960 | MPa | ASTM D790 |
| bending strength | |||
| yield | 114 | MPa | ASTM D790 |
| compressive strength | 148 | MPa | ASTM D695 |
| Babbitt hardness | 35 | ASTM D2583 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type I |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |