| About |
|---|
| Material Type: Red color fluoroelastomer compound, hardness Shore A 70-80. Based on bisphenol curable terpolymer which is higher fluorine content than copolymer. Features: Excellent mold flow, hot tear resistance, bonding adhesion, good resistance to the fuel containing alcohols. Process Methods: Suitable for compression and transfer molding processes. Applications: oil seals, stem seals, crank shaft seals and complicated geometries. Lab Testing Curing Condition: Press Curing: 10min@170°C. Oven: (8+16)hrs@230°C&& |
| Product Description | |
|---|---|
| Supplier | Fluoro |
| Generic | 氟橡胶 |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Ethanol tolerance,Good liquidity,Good bond,Good tear strength,Agglomerability,Fuel resistance |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.92 | g/cm³ | ASTM D792 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 77 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 13.8 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 260 | % | ASTM D412 |
| Compression deformation | |||
| 200℃，70 hr | 29 | % | ASTM D395 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| The rate of change in tensile strength in air | |||
| 250℃，70 hr | -13 | % | ASTM D573 |
| The rate of change in ultimate elongation in air | |||
| 250℃，70 hr | -11 | % | ASTM D573 |
| The rate of change in hardness of a hardness tester in the air | |||
| 250℃，70 hr | 2.0 | ASTM D573 | |
| The rate of change in tensile strength | |||
| 23 ℃, 70 hr, C-grade standard fuel | -12 | % | ASTM D471 |
| Change rate of ultimate elongation | |||
| 23 ℃, 70 hr, C-grade standard fuel | -11 | % | ASTM D471 |
| The rate of change in Shore hardness | |||
| 23 ℃, 70 hr, in reference fuel C | -2.0 | ASTM D471 | |
| Volume change | |||
| 23 ℃, 70 hr, C-grade standard fuel | 2.0 | % | ASTM D471 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 6 mm Buttons |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |