| About |
|---|
| FR4832 is a Chemically Crosslinkable Polyethylene Compound for Primary Automotive Wires. Applications FR4832 is intended for use as a 125° C rated primary insulation for crosslinked automotive wire. Specifications FR4832 in combination meets the applicable requirements as below when processed using sound extrusion and testing procedure: SAE J1128/J1127&& |
| Product Description | |
|---|---|
| Supplier | Borealis AG |
| Generic | XLPE |
| Material Status | Commercial: Active |
| Features | Crosslinked |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.40 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 17.3 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 200 | % | ASTM D412 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 50 | ASTM D2240 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -50.0 | ℃ |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Retention rate of tensile performance | |||
| After Ageing，165℃ | > 80 | % |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 1.0E+16 | ohms·cm | ASTM D257 |
| Dielectric strength | > 550 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 23 ℃，60 Hz | 3.70 | ASTM D150 | |
| Dissipation factor | |||
| 23℃，60 Hz | 0.010 | ASTM D150 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Extreme oxygen index | 25 | % | ASTM D2863 |
| Flame Test | Pass | Multiple Standards |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 55 | °C | |
| Drying time | 2.0 to 8.0 | hr | |
| Barrel 1 zone temperature | 96 | °C | |
| Connector temperature | 110 | °C | |
| Melt temperature | 120 to 125 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 240 h |
| 3. ISO 6722/SAE J1128, 20 AWG – 16 mil cable |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |