About |
---|
Bormed LE6601-PH is a resin intended for evaluation for use in Healthcare applications. Bormed LE6601-PH is an additive free low density polyethylene which is used to produce soft and flexible packages for pharmaceutical products. The material can be converted via blow moulding, including BFS technology, or IBM into small bottles or ampoules. However, material can as well be used in injection moulding and blown film process. The flexibility of the materials will facilitate the dosing of the medicine when used in ampoules and bottles. Articles made from Bormed LE6601-PH can be steam sterilised at maximum 105 °C. Material can be sterilised with ethylene oxide as well with radiation up to 35 kGy.&& |
Product Description | |
---|---|
Supplier | Borealis AG |
Generic | LDPE |
Material Status | Commercial: Active |
Features | Good flexibility,Renewable resources,Low density,Soft |
Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
Technical Data | |||
---|---|---|---|
PHYSICAL | Nominal value | Unit | Test method |
Density | 0.922 | g/cm³ | ISO 1183 |
Melt Flow Rate | |||
190℃,2.16kg | 1.5 | g/10min | ISO 1133 |
MECHANICAL | Nominal value | Unit | Test method |
---|---|---|---|
Tensile modulus | 240 | MPa | ISO 527-1-2 |
tensile strength | |||
yield | 10.0 | MPa | ISO 527-2/50 |
Bending modulus | 200 | MPa | ISO 178 |
THERMAL | Nominal value | Unit | Test method |
---|---|---|---|
Hot deformation temperature | 49 | ℃ | ISO 75-2 |
Process Conditions | |||
---|---|---|---|
injection | Nominal value | Unit | Test method |
Processing (melt) temperature | 165 to 200 | °C |
Notes |
---|
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |