| About |
|---|
| Product Information: TPO’s are a family of thermoplastic elastomers which exhibit rubber-like properties and are processable on conventional thermoplastic equipment. Features: Tear Resistance, High UV Resistance, Good Density, Low Wide service range from -20 degrees C to 120 degrees C&& |
| Product Description | |
|---|---|
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Low density,Good tear strength |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 230℃，2.16kg | 14 to 20 | g/10min | ASTM D1238 |
| Ash Content | 4.0 to 6.0 | % | ASTM D5630 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | > 530 | J/m | ASTM D256 |
| Drop hammer impact | > 407 | J | ASTM D5420 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 62 to 68 | ASTM D2240 | |
| tensile strength | |||
| yield | > 16.0 | MPa | ASTM D638 |
| Bending modulus | > 700 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |