Braskem PE HS5407

About
Braskem PE HS5407 HS5407 is a high molecular weight, high-density polyethylene, copolymer. Exhibit excellent wall thickness uniformity, an improved balance between stiffness and impact and high environmental stress cracking resistance (ESCR). Applications: Blow Molded Large Parts: Drums for chemical, agricultural and food products up to 200 liters; Sheet extrusion for pickup rear protectors (bedliner). Process: Blow Molding.&&Braskem PE HS5407 HS5407 is a high molecular weight, high-density polyethylene, copolymer. Exhibit excellent wall thickness uniformity, an improved balance between stiffness and impact and high environmental stress cracking resistance (ESCR). Applications: Blow Molded Large Parts: Drums for chemical, agricultural and food products up to 200 liters; Sheet extrusion for pickup rear protectors (bedliner). Process: Blow Molding.&&

About

Braskem PE HS5407 HS5407 is a high molecular weight, high-density polyethylene, copolymer. Exhibit excellent wall thickness uniformity, an improved balance between stiffness and impact and high environmental stress cracking resistance (ESCR). Applications: Blow Molded Large Parts: Drums for chemical, agricultural and food products up to 200 liters; Sheet extrusion for pickup rear protectors (bedliner). Process: Blow Molding.&&Braskem PE HS5407 HS5407 is a high molecular weight, high-density polyethylene, copolymer. Exhibit excellent wall thickness uniformity, an improved balance between stiffness and impact and high environmental stress cracking resistance (ESCR). Applications: Blow Molded Large Parts: Drums for chemical, agricultural and food products up to 200 liters; Sheet extrusion for pickup rear protectors (bedliner). Process: Blow Molding.&&

Product Description
Supplier	Braskem
Generic	HDPE
Material Status	Commercial: Active
Features	Food contact compliance,High molecular weight,Copolymer,High density,High ESCR
Availabilitys	Latin America,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.954	g/cm³	ASTM D792
Melt Flow Rate
190℃，2.16kg	7.00	g/10min	ASTM D1238

MECHANICAL	Nominal value	Unit	Test method
tensile strength
23℃	35	MPa	ASTM D638
Bending modulus
23℃	1250	MPa	ASTM D790

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	70	℃	ASTM D648

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
-40℃	400	J/m	ASTM D256

Notes
1. Typical properties: these are not to be construed as specifications.
2. Compression Molded
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.