| About |
|---|
| LDF6522 resin is a low density polyethylene designed for cast extrusion and injection molding sectors. It is used for flexible packaging and cardboard coating. It offers low neck in and optimum extrusion speed (Draw down). This resin meets U.S. FDA 21 CFR 177.1520. Applications: Extrusion Coating, Caps Injection, Masterbatch, Packaging for snacks, juices and condiments. Process: Cast Film Extrusion. Injection molding.&& |
| Product Description | |
|---|---|
| Supplier | Braskem |
| Generic | LDPE |
| Material Status | Commercial: Negative |
| Features | Low shrinkage |
| Availabilitys | North America,Latin America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.922 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 6.5 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 85.0 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 50 | ASTM D2240 | |
| tensile strength | |||
| yield | 11.2 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 530 | % | ASTM D638 |
| Bending modulus | 210 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |