Braskem PE LH-118

About
Description: LH118 is a Linear Low Density Polyethylene, copolymer of hexene-1, produced by Spherilene process. Developed for blown film extrusion in blends with polyethylenes. Films obtained with this product show a good processing performance balanced with good optical and mechanical properties as well as sealability. Very low gel amount. It contains antioxidant additives. Applications: Stretch films; liners; LDPE and HDPE blends and packages for general use. Others applications: blends for irrigation pipes. Process: Recommended processing conditions for film extrusion about 170 – 210 °C.&&

About

Description: LH118 is a Linear Low Density Polyethylene, copolymer of hexene-1, produced by Spherilene process. Developed for blown film extrusion in blends with polyethylenes. Films obtained with this product show a good processing performance balanced with good optical and mechanical properties as well as sealability. Very low gel amount. It contains antioxidant additives. Applications: Stretch films; liners; LDPE and HDPE blends and packages for general use. Others applications: blends for irrigation pipes. Process: Recommended processing conditions for film extrusion about 170 – 210 °C.&&

Product Description
Supplier	Braskem
Generic	Linear low density polyethylene
Material Status	Commercial: Active
Features	Excellent Processability,Optical performance,Low speed solidification point,Food contact compliance,Inoxidizability,Low density,Copolymer,Hexene copolymers
Availabilitys	Latin America,Europe
Process Methods	Film extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.916	g/cm³	ASTM D1505
Melt Flow Rate
190℃，2.16kg	1.0	g/10min	ASTM D1238

film	Nominal value	Unit	Test method
tensile strength
TD, fracture, 40 µ m, blow molded film	40.0	MPa	ASTM D882
MD, fracture, 40 µ m, blow molded film	40.0	MPa	ASTM D882
Tensile strain
TD, fracture, 40 µ m, blow molded film	1400	%	ASTM D882
MD, fracture, 40 µ m, blow molded film	1100	%	ASTM D882
Bending modulus
1% secant, TD, 40 µ m, blow molded film	210	MPa	ASTM D790
1% secant, MD, 40 µ m, blow molded film	200	MPa	ASTM D790
Drop hammer impact
40 µ m, blow molded film	150	g	ASTM D1709
tear strength
TD, 40 µ m, blow molded film	510	g	ASTM D1922
MD, 40 µ m, blow molded film	300	g	ASTM D1922

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.