| About |
|---|
| Braskem PE SPB608 SPB608 is a low density polyethylene designed for injection molding. This grade shows excellent processability being indicated for applications where low viscosity is required during processing. Injection molded products with this resin shows good flexibility. Additives free. The minimum biobased content of this grade is 95%, determined according to ASTM D6866. Applications: Masterbatches. Covers and injected parts with large flat area.&&Braskem PE SPB608 SPB608 is a low density polyethylene designed for injection molding. This grade shows excellent processability being indicated for applications where low viscosity is required during processing. Injection molded products with this resin shows good flexibility. Additives free. The minimum biobased content of this grade is 95%, determined according to ASTM D6866. Applications: Masterbatches. Covers and injected parts with large flat area.&&Braskem PE SPB608 SPB608 is a low density polyethylene designed for injection molding. This grade shows excellent processability being indicated for applications where low viscosity is required during processing. Injection molded products with this resin shows good flexibility. Additives free. The minimum biobased content of this grade is 95%, determined according to ASTM D6866. Applications: Masterbatches. Covers and injected parts with large flat area.&& |
| Product Description | |
|---|---|
| Supplier | Braskem |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good flexibility,Renewable resources,Low Viscosity |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.915 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 30 | g/10min | ASTM D1238 |
| Biobased Content | 95 | % | ASTM D6866 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 39 | ASTM D2240 | |
| tensile strength | |||
| Fracture, molded | 8.00 | MPa | ASTM D638 |
| Yield, molding | 8.00 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, molded | 390 | % | ASTM D638 |
| Bending modulus | |||
| 1% cut, molded | 450 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 79.0 | ℃ | ASTM D1525 2 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |