| About |
|---|
| RP 270G is a low melt flow Random Copolymer for containers, bottles and packaging for parental solutions with good transparency. Applications: Extrusion Blow Molding (EBM) of containers, bottles, houseware. Packaging for parenteral solutions. Processing: Extrusion Blow Molding&& |
| Product Description | |
|---|---|
| Supplier | Braskem |
| Generic | PP copolymer |
| Material Status | Commercial: Active |
| Features | Low liquidity,Random copolymer |
| Availabilitys | Latin America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.902 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 1.5 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ℃, injection molding | 100 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed, injection molded | 84.0 | ℃ | ASTM D648 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 77 | ASTM D785 | |
| tensile strength | |||
| Yield, injection molding | 27.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, injection molding | 13 | % | ASTM D638 |
| Bending modulus | |||
| 1% cut, injection molding | 900 | MPa | ASTM D790 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |