| About |
|---|
| PHB-07 is a certified prime grade Polypropylene designed for specialty applications requiring superior tensile strength and toughness. PHB-07 combines excellent processability with high degree of thermal stabilization, high melt strength and outstanding mechanical properties of end-products. PHB-07 applications include blow molding, strapping tape, thin-wall sheet thermoforming, small diameter pipe and profiles. PHB-07 recommended processing temperature is between 210° to 230°C. PHB-07 complies with FDA regulation 21CFR 177.1520 and with most international regulations concerning the use of Polypropylene in contact with food.&& |
| Product Description | |
|---|---|
| Generic | HMS PP |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Food contact compliance,Good melt strength,Ultra high toughness,Good Tensile Strength,Heat Stabilized,Homopolymer |
| Availabilitys | North America |
| Process Methods | Thermo forming |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.905 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 0.70 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | |||
| injection molding | 1690 | MPa | ASTM D638 |
| tensile strength | |||
| Yield, injection molding | 37.2 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, injection molding | 60 | % | ASTM D638 |
| Bending modulus | |||
| 1% cut, injection molding | 1650 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ℃, injection molding | 120 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed, injection molded | 114 | ℃ | ASTM D648 |
| Vicat Softening Temp | 152 | ℃ | ASTM D1525 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 99 to 110 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 3. 0.051 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |