| About |
|---|
| CONAPOXY FR-1830 is a ambient cure, two-component, low viscosity, flame retardant epoxy potting, casting, and coating system with excellent handling properties. CONAPOXY FR-1830 contains a non-abrasive filler to reduce wear on machine metering/dispensing equipment. CONAPOXY FR-1830 is recognized to UL 94V-0 and is RoHS compliant. Products produced using CONAPOXY FR-1830 can be shipped into the European Union, however shipment into the EU of uncured part A and part B is restricted.&& |
| Product Description | |
|---|---|
| Supplier | Cytec Industries |
| Generic | 环氧树脂 |
| Material Status | Commercial: Active |
| Features | Low Viscosity,Flame Characteristics,V-0 |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | |||
| — | 0.965 | g/cm³ | |
| — | 1.59 | g/cm³ | |
| Water absorption rate | |||
| 24hr | 0.34 | % | |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | 2.0E+15 | ohms | |
| Volume resistivity | |||
| 25 ℃ | 6.9E+14 | ohms·cm | |
| Dielectric strength | 20 | kV/mm | |
| Dielectric constant | |||
| 25 ℃，1 kHz | 4.14 | ||
| Dissipation factor | |||
| 25℃，1 kHz | 0.017 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 4.8 mm | V-0 | UL 94 |
| Thermosetting mixed viscosity | Nominal value | Unit | Test method |
|---|---|---|---|
| 25℃ | 2190 | cP |
| Cured Properties | Nominal value | Unit | Test method |
|---|---|---|---|
| Linear Shrinkage | 0.067 | % |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 80 to 85 | ||
| tensile strength | 35.9 | MPa |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Thermal conductivity coefficient | 0.49 | W/m/K | |
| Thermosetting components | |||
| resin | 按重量计算的混合比: 100 | ||
| Hardening method | 按重量计算的混合比: 20 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Hardener |
| 3. Resin |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |