| About |
|---|
| Nylon works very well as a glass filled product in the CPI Binani D-LFT process. It offers improved resistance to impact, modulus, and flex while creating a nice finished product with a pleasant finish. Nylon is somewhat heavier than polypropylene which may be a consideration when selecting materials for your product. The engineering staff at CPI Binani can provide additional information based on your completed Product Requirements Document (PRD)&& |
| Product Description | |
|---|---|
| Generic | PA6 |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Tensile modulus | 13100 | MPa | |
| tensile strength | 214 | MPa | |
| Bending modulus | 10300 | MPa | |
| bending strength | 324 | MPa | |
| Poisson’s ratio | 0.35 | ||
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 350 | J/m |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |