CYREX® Protect

About
CYREX® Protect is an opaque acrylic-polycarbonate alloy providing antimicrobial capabilities* against a variety of microorganisms commonly found in healthcare facilities. It is the latest addition to the family of Evonik Cyro’s advanced polymers for antimicrobial medical device applications. Offering outstanding impact strength and toughness, CYREX® alloys empower designers to create better-than-ever medical devices. Typical Medical Applications Luer fittings Spikes Protection caps and covers Adapters Fittings Valve assemblies Sharp needle dispenser receptacle&&

About

CYREX® Protect is an opaque acrylic-polycarbonate alloy providing antimicrobial capabilities* against a variety of microorganisms commonly found in healthcare facilities. It is the latest addition to the family of Evonik Cyro’s advanced polymers for antimicrobial medical device applications. Offering outstanding impact strength and toughness, CYREX® alloys empower designers to create better-than-ever medical devices. Typical Medical Applications Luer fittings Spikes Protection caps and covers Adapters Fittings Valve assemblies Sharp needle dispenser receptacle&&

Product Description
Supplier	Evonik
Generic	PC+ PMMA
Material Status	Commercial: Active
Features	Excellent Processability,Good flexibility,High impact resistance,Ethanol tolerance,Antimicrobial properties,E-beam disinfection,Radiation disinfection,Heat Resistance, Good,Ethylene oxide disinfection,Agglomerability
Availabilitys	North America,Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.16	g/cm³	ASTM D792
Melt Flow Rate
230℃，3.80kg	3.0	g/10min	ASTM D1238
Water absorption rate
balance	< 0.26	%	ASTM D570

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃，3.2mm	640	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, annealed, 6.35 mm	96.1	℃	ASTM D648
Vicat Softening Temp	130	℃	ASTM D1525

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	2140	MPa	ASTM D638
tensile strength	54.5	MPa	ASTM D638
Tensile strain
fracture	25	%	ASTM D638
yield	4.0	%	ASTM D638
Bending modulus	2070	MPa	ASTM D790
bending strength	92.4	MPa	ASTM D790
Rockwell hardness
M-level	45		ASTM D785

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	82	°C
Drying time	3.0 to 4.0	hr
Processing (melt) temperature	238 to 260	°C
Mold temperature	65 to 99	°C

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.