| About |
|---|
| Daelim Po1y® LD-18A is a Low Density Polyethylene product. It is available in Asia Pacific or Europe. Applications of Daelim Po1y® LD-18A include food contact applications and packaging. Characteristics include: Antiblock High Gloss&& |
| Product Description | |
|---|---|
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | Good surface appearance,High anti-blocking |
| Availabilitys | Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.921 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 2.3 | g/10min | ASTM D1238 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | |||
| test | 30 | µm | |
| tensile strength | ASTM D882 | ||
| MD, fracture | 20.6 | MPa | |
| TD, fracture | 19.6 | MPa | |
| Tensile strain | ASTM D882 | ||
| MD, fracture | 450 | % | |
| TD, fracture | 580 | % | |
| Drop hammer impact | 100 | g | ASTM D1709 |
| Elmandorf tear strength | ASTM D1922 | ||
| MD | 10 | g | |
| TD | 7.0 | g |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Haze | 6.0 | % | ASTM D1003 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 160 to 175 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |