| About |
|---|
| Daelim Po1y® XP9200EN is a Metallocene Linear Low Density Polyethylene product. It is available in Asia Pacific or Europe. Applications of Daelim Po1y® XP9200EN include agricultural, coating applications, film, food contact applications and wrap. Characteristics include: Good Sealability Antioxidant Clarity Good Stiffness Good Toughness&& |
| Product Description | |
|---|---|
| Generic | mLLDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good Clarity,Low extract,Good flexibility,Good surface appearance,Good heat sealing,Inoxidizability,Low temperature heat sealing |
| Availabilitys | Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.917 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 1.0 | g/10min | ASTM D1238 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D882 | ||
| MD : Break, 1.2 mil, Blown Film | 56.9 | MPa | ASTM D882 |
| TD, fracture, 30 µ m, blow molded film | 45.1 | MPa | ASTM D882 |
| Tensile strain | ASTM D882 | ||
| MD : Break, 1.2 mil, Blown Film | 580 | % | ASTM D882 |
| TD, fracture, 30 µ m, blow molded film | 620 | % | ASTM D882 |
| Drop hammer impact | |||
| 30 µ m, blow molded film | 700 | g | ASTM D1709-B |
| Initial sealing temperature | |||
| 30 µ m, blow molded film | 95.0 | ℃ | Internal Method |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | ASTM D1004 | ||
| TD，0.0300 mm | 125 | kN/m | ASTM D1004 |
| MD，0.0300 mm | 122 | kN/m | ASTM D1004 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 106 | ℃ | ASTM D1525 |
| Melting peak temperature | 116 | ℃ | ASTM D3418 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | |||
| 45 °, 30 µ m, blow molded film | 87 | ASTM D2457 | |
| Haze | |||
| 30 µ m, blow molded film | 12 | % | ASTM D1003 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 150 to 190 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. HGT, 2.8 kg, 0.5 sec |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |