Daicel PA PA9T-GF50-01

About
Daicel PA PA9T-GF50-01 is a Polyamide material filled with 50% long glass fiber. It is available in Asia Pacific.&&

Product Description
Supplier	Daicel
Generic	PA Not specified
Material Status	Commercial: Active
Availabilitys	Asia Pacific

Technical Data

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	120	°C
Drying time	3.0 to 5.0	hr
Barrel rear temperature	310 to 330	°C
Barrel middle temperature	320 to 330	°C
Barrel front temperature	320 to 330	°C
Nozzle temperature	310 to 330	°C
Mold temperature	130 to 150	°C
Back pressure	5.00 to 10.0	MPa
Screw speed	40 to 60	rpm

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.