| About |
|---|
| Examples of applications Governors Plug caps Connectors Coil bobbins Terminal strips Automobiles Railways/Aircraft Ship components&& |
| Product Description | |
|---|---|
| Generic | DAP增塑剂 |
| Material Status | Commercial: Active |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.60 to 1.70 | g/cm³ | JIS K6911 |
| Shrinkage rate | |||
| — | 0.50 to 0.80 | % | |
| — | 0.40 to 0.70 | % | |
| Water absorption rate | |||
| boiling | 0.15 to 0.25 | % | JIS K6911 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| bending strength | |||
| Compression Molding | 69.0 to 98.0 | MPa | |
| injection molding | 98.0 to 147 | MPa |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| Compression Molding | 2.9 to 4.9 | kJ/m² | |
| injection molding | 3.4 to 5.4 | kJ/m² |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | 170 to 180 | ℃ | JIS K6911 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 12 to 16 | kV/mm | JIS K6911 |
| Dielectric constant | |||
| — | 4.40 to 4.70 | ||
| — | 4.40 to 4.60 | ||
| Dissipation factor | |||
| — | 0.012 to 0.015 | ||
| — | 0.012 to 0.017 | ||
| Arc resistance | > 120 | sec | JIS K6911 |
| Compared to the leakage tracing index | > 600 | V | IEC 60112 |
| insulation resistance | |||
| After boiling | 1.0E+13 to 1.0E+14 | ohms | |
| at ordinary state | 1.0E+14 to 1.0E+15 | ohms | |
| surface | 1.0E+8 to 1.0E+10 | ohms | |
| volume | 1.0E+9 to 1.0E+10 | ohms |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.00 mm | HB | UL 94 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Thermal shrinkage | 0.050 to 0.10 | % | JIS K6918 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Compression Molding |
| 3. Injection Molding |
| 4. after immersion in water |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |