Deltron 5365

About
Deltron 5365 is a Polyphenylene Sulfide (PPS) material. It is available in Asia Pacific for injection molding. Important attributes of Deltron 5365 are: Flame Rated Wear Resistant&&

Product Description
SupplierLin Gen
GenericPPS
Material StatusCommercial: Active
FeaturesGood wear resistance,V-0
AvailabilitysAsia Pacific
Process MethodsInjection Molding

Technical Data
PHYSICALNominal valueUnitTest method
Density1.80g/cm³
Shrinkage rate
MD0.20 to 0.50%
Water absorption rate
balance0.020%

IMPACTNominal valueUnitTest method
Impact strength of cantilever beam notch9.00kJ/m²

THERMALNominal valueUnitTest method
Hot deformation temperature
1.8 MPa, unannealed265
Melting temperature285
Linear coefficient of thermal expansion
MD1.9E-51/℃

Electrical performanceNominal valueUnitTest method
Surface resistivity1.2E+14ohms
Volume resistivity2.5E+16ohms·cm
Dielectric strength15kV/mm
Dielectric constant
1 MHz3.20 

FLAME CHARACTERISTICSNominal valueUnitTest method
Flame retardant level
2.00 mmV-0 

MECHANICALNominal valueUnitTest method
Rockwell hardness
R-level100 
tensile strength130MPa
Tensile strain
fracture1.6%
Bending modulus12000MPa
bending strength190MPa
compressive strength150MPa

Process Conditions
injectionNominal valueUnitTest method
Drying temperature120 to 140°C
Drying time4.0 to 8.0hr
Barrel rear temperature240 to 260°C
Barrel middle temperature290 to 310°C
Barrel front temperature300 to 330°C
Mold temperature100 to 140°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.