| About |
|---|
| DERAKANE 510 B-400 Epoxy Vinyl Ester Resin is a low viscosity, unpromoted, flame retardant”) epoxy vinyl ester. This resin offers offers exceptional processing characteristics including little to no foaming, excellent exotherm control, and industry-leading storage stability. Laminates made with DERAKANE 510 B-400 resin have achieved a flame spread of 25 (ASTM E-84). DERAKANE 510 B-400 resin gives final products with: Excellent flame retardancy High strength characteristics Excellent impact strength and toughness Fast wet-out and low drainage Excellent corrosion resistance to acidic and alkaline environments APPLICATIONS AND USE DERAKANE 510 B-400 resin can be used for corrosion resistant, reinforced thermosetting plastic equipment including filament wound, hand lay-up and spray-up tanks, pipes, ducts, stacks, scrubbers, linings or other equipment handling corrosive gases, vapors or liquids where a high degree of flame retardancy is required.&& |
| Product Description | |
|---|---|
| Generic | 乙烯基酯 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability,Good flexibility,Alkali resistant,High impact resistance,Low Viscosity,Corrosion Resistant,Flame Characteristics,Acidproof |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Solution viscosity | 425 | mPa·s | |
| Gardner color | < 5.00 | ||
| Solid content | 57 | % | |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 106 | ℃ | ASTM D648 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Babbitt hardness | 35 | ASTM D2583 | |
| Tensile modulus | 3520 | MPa | ASTM D638 |
| tensile strength | 90.0 | MPa | ASTM D638 |
| Tensile strain | ASTM D638 | ||
| yield | 4.7 | % | ASTM D638 |
| fracture | 5.5 | % | ASTM D638 |
| Bending modulus | 3450 | MPa | ASTM D790 |
| bending strength | 152 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Brookfield #2 spindle @ 30 rpm |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |